System crashes with Application Control bug check E0100010 on every boot

技術的な記事 ID: KB83203
最終更新: 2/7/2021

環境

McAfee Application and Change Control (MACC) 6.1
Microsoft Windows (all supported versions)

概要

This article describes an issue where the system might crash on every boot cycle with bug check E0100010.

問題

MACC-generated bug check E0100010 is a crash that occurs if the system boots in Enable mode and the inventory (allow list) is corrupt. A scan is performed on the inventory to determine if it is corrupted. When found, inventory corruption triggers an MACC recovery process. This recovery process forces the system to crash and boot into Disable mode.

原因

The inventory (allow list) can become corrupt in the following scenarios:

A crash or hard reboot occurs while the inventory is being updated with changes to files on the system.
The inventory has been edited or tampered with in Disable mode or Update mode.

解決策

This issue is resolved in MACC 6.1.3.392 and later. If upgrading is not a viable option, perform one of the workarounds provided in this article.

回避策

Steps to recover:

Boot the system in Safe Mode with Networking.
Open a command prompt and run the scsrvc -d command.
NOTE: Keep the command prompt running.
Open another command prompt and run the sadmin disable command.
Reboot in normal mode.
Run the sadmin so command or push the solidification task from ePO and resolidify the system.
Enable MACC with the command sadmin enable or the enable task from ePO.

回避策

CAUTION: This article contains information about opening or modifying the registry.

The following information is intended for System Administrators. Registry modifications are irreversible and could cause system failure if done incorrectly.
Before proceeding, Technical Support strongly recommends that you back up your registry and understand the restore process. For more information, see: http://support.microsoft.com/kb/256986.
Do not run a REG file that is not confirmed to be a genuine registry import file.

Place MACC in Disable mode by performing the following steps:

Boot the system into Safe Mode (press F5 before the Windows boot screen).
Open the Registry editor. Click Start, Run, type regedit, and click OK.
Navigate to the following registry key:

[HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\swin\Parameters]

Double-click DWORD RTEMode and change the value to 0.
Double-click DWORD RTEModeOnReboot and change the value to 0.
Reboot the system. MACC is now in Disable mode.

影響を受ける製品

Application and Change Control 6.1
Known Issue/Product Defect

言語:

この記事は、次の言語で表示可能です:

English United States
Spanish Spain
French
Italian
Japanese
Portuguese Brasileiro

技術用語集

用語集にある用語をハイライトする

当社の技術用語集を参照してください。

Knowledge Center

System crashes with Application Control bug check E0100010 on every boot

環境

概要

問題

原因

解決策

回避策

回避策

影響を受ける製品

言語:

技術用語集

Title

Title

Knowledge Center

System crashes with Application Control bug check E0100010 on every boot

環境

概要

問題

原因

解決策

回避策

回避策

影響を受ける製品

言語:

技術用語集

地域を選択してください

Title

Title